- Cooling System
- Stops Leaks
- Stops & Seals Coolant Leaks
- Works with Any Color Antifreeze
- Stops Leaks and Drips from Wear and Age
- Seals Leaks in Radiator, Heater Core & Freeze Plugs
This product is specifically designed to be directly added to the cooling system with out having to flush out the antifreeze.
Yes, Rislone is compatible with both conventional green (silicate-based) and extended life red/orange or yellow (OAT) antifreeze.
Rislone will seal external, internal and coolant to oil leaks. Once installed, the Rislone particles shrink up to 15 percent. On an external leak, the tiny particles flow to the point of the leak. They then collect at the outside of the seepage and build inward. Internal leaks, the Bars Leaks particles will burn when subjected to the 2,500 C degree heat of the combustion chamber to seal head gasket seepage and small cracks. On coolant to oil leaks, where coolant can seep into the crankcase contaminating the oil, the tiny Rislone particles will seal the pores in cast iron and aluminum preventing seepage.
We recommend you drive/idle vehicle for 15 to 20 minutes. In most cases the leak will be sealed with in this amount of time. If the leak is not sealed, a second application maybe required.
No, the tiny particles will pass through a 24-gauge mesh screen which is the spec for the BIG 3 car/truck manufacturers. They say that any product installed in the cooling system must pass through this screen. Rislone is the only stop leak to pass this test and to be approved by the vehicle manufacturers.
Note: If using Rislone to stop heater core leaks, make sure you turn your heater control to HOT. Some vehicles have a valve that controls coolant flow through the core.
One 325 mL bottle treats (11) litres.
Rislone is only designed to be added to the cooling system. If the product is installed in the gas tank, the tank should be removed and cleaned out by a professional mechanic.
Rislone is only designed to be added to the cooling system. If the product is installed in the engine oil and the engine has not been started, in many cases you can remove the valve cover and drain the oil leaving the drain plug off. Then use an engine flush washing out the head keeping special attention to the oil return holes that run down to the oil pan. Clean these out and pour the engine flush down these holes flushing everything into the oil pan and out the drain hole. If the engine has been run, you need to take the vehicle to have a professional mechanic evaluate what can be done to clean the inside of the engine. This might include taking the engine apart to clean all of the parts.
Noticing a puddle of fluid under your car is never a good way to start your day. What you need is a safe and easy way to stop that leak so you can get on with your day as planned. Our Rislone Radiator Stop Leak will do just that.
This product is specially designed to stop minor cooling system leaks and drips caused by normal cooling system wear and age. It works with ALL types and colors of antifreeze coolant and/or water.
Before you know it, you’ll stop that leak and get your car back on the road. Yes, you. No mechanic required.